ShawSoutheast Fairbanks, Alaska | 2026

Retained report · Exact WFIGS/NIFC source record · More reports in Alaska

View fire map Official resources
Share & export
Export reports CSV
Share

At a glance

The last saved WFIGS/NIFC record for Shaw in Southeast Fairbanks, Alaska reports 3,459.2 acres and 0% containment.

Reported area3,459.2acres / 1,399.9 hectares
Reported containment0%
Discovery dateJun 20, 2026Reported discovery, not verified ignition time
Reported locationSoutheast Fairbanks, AlaskaAgency location record
0%

Containment does not tell you whether the fire is out.

Agency record updated
Retrieved by WildfireSignal

Recent saved changes

Not enough saved reports are available to compare this incident. Missing history is not zero activity.

Observed source changes do not establish ignition or extinguishment. Reported acreage can be revised after mapping corrections. View saved report history →

Shaw map

The fire pin and blue ring mark this incident's reported point. They are not a fire boundary or evacuation zone.

Alaska overview →
Filters
Time Window
Heat Intensity
Very strong>330 K
Strong300-330 K
Satellite heat Map layer loading…
Wildfire Overview
Current map view
Heat detections --
Very strong --
Last update --
Layers
Official fire Perimeter Strong heat Very strong
Reported incident locationSatellite heat, not attributed to this fireAgency perimeter when available via Layers

About Shaw

The agency recorded discovery on Jun 20, 2026, 7:01 PM ET. The reported cause is listed as "Natural".

The agency describes the location or incident as: “23 Miles NE from Delta Junction, AK”.

Jurisdiction is listed as DNR. Reported fire behavior: Moderate.

Discovery
Jun 20, 2026
Reported cause
Natural
Agency
DNR

Source: facts and saved reports from WFIGS/NIFC agency records. Check the report date for the timing of these details. How we use this data.

Saved report history for Shaw

Saved WFIGS/NIFC observations show how the agency-reported area and containment have changed. WildfireSignal does not estimate values between reports.

Too few agency reports were saved to compare changes for this retained record.

Fire details

Reported location
Southeast Fairbanks, Alaska
Discovery
Reported cause
Natural
Primary fuel / fuel model
Timber (Grass and Understory)
Secondary fuel / fuel model
Short Grass (1 foot)
Reported fire behavior
Moderate
Behavior detail
Smoldering
Behavior detail
Running
Jurisdictional agency
DNR
Management organization
Type 5 IC
Incident complexity
Type 5 Incident
Incident identifier
2026-AKDAS-612226
Situation report date
Reported coordinates
64.3795, -145.4434

Optional facts appear only when present in the feed. Agency abbreviations and fuel-model labels are shown as reported, without guessing missing details.

Questions about Shaw

Where is Shaw?

The official incident record places it in Southeast Fairbanks, Alaska. The map pin is a reported location, not the full fire boundary.

How large is Shaw?

The retained record reports 3,459.2 acres (approximately 1,399.9 hectares). This is reported incident size, not a measurement of current flames, and agencies can revise it.

How contained is Shaw?

The retained record reports 0% containment. Containment describes control work intended to stop spread. It is not the percentage extinguished or an all-clear for nearby communities.

When was Shaw discovered?

The reported discovery date is Jun 20, 2026, 7:01 PM ET. Discovery time may differ from ignition time; elapsed time does not establish continuous burning.

Where should I check evacuation orders and road closures?

Use local emergency management, the sheriff or other law enforcement, and official fire-agency updates. WildfireSignal does not verify evacuation zones, open roads, or safe travel routes. The official-information section provides starting points; it does not establish that orders are present or absent.

Why can the map and the incident report differ?

Agency records, mapped perimeters and NASA satellite detections are updated on different schedules. Satellite heat near a fire is not automatically attributed to that incident. Older or unavailable data does not establish that an area is safe.

Source details & methodologyHow this page uses agency, satellite and map data

This page combines agency incident reporting with separate satellite and map layers. They can update at different times and answer different questions.

Agency report

WFIGS / NIFC

Use this for the reported fire name, acreage, containment, incident location and agency update time shown on this page.

Satellite observations

NASA FIRMS

Heat detections can show recent thermal activity, but they are not an official acreage or containment figure and are not automatically attributed to this incident.

Boundary context

Agency perimeter layer

When a perimeter is available in the map layers, it may have a different timestamp from the incident report. The fire pin itself is only a reported location.